Installing Louverdrape vertical blinds is extremely simple.

Installing Louverdrape vertical blinds
is extremely simple,

thanks to the thorough and meticulous preparatory work done in the factory. If you observe the following instructions and carry them out in this order, nothing can go wrong.

1. Open the packing cylinder at the end showing this instruction. You will see a rail, runners, a control cord, a cord weight and a chain - everything is complete and mounted securely to measure.

2. Attach the rail in a straight line (to the ceiling or to brackets) using the screws provided. If necessary, drill extra 5mm holes exactly in the appropriate slot in the middle of the rail.

3. If you need longer screws, buy exactly the same model as the Louverdrape screws, with a cylindrical head. Do not use screws with a sunken head.

4. Make sure beforehand that there is enough room for the slats to move and that they are not hindered by any glass, groove, windowsill, window knobs, radiators or other protrusions.

5. Install the slats.

In the case of Louverdrape textile slats do observe the following points:

* The side of the slats where the seam is visible should all face the same direction.

* Insert two ballast weights into every slat so that the weights make a perfect match (male / female). Keep the chains on top of the strips.

smaller slat hanger

* If your Louverdrape can be drawn into two directions, you will come across two slats with a smaller slat hanger at the top. These two slats should go in the middle of the rail.

In the case of Louverdrape synthetic slats:

* Never fold or roll up slats, always keep them in a flat position while handling them.